Items Required for Making Bacteriostatic Water10cc syringe, (needed to measure the benzyl alcohol)0.1cc benzyl alcohol,10cc sterilized water,0.22 syringe pore filter,
10cc sterile vial
Alcohol Pads (You may need the theifs to wipe down the vial tops)
Two 18gauge pins one for drawing water and something for injecting in sterile vial.
Small pin 27gauge for letting air pressure out of vial you injecting benzyl alcohol into
Water:No need to boil water, but use sanitized water or water that has been subject to ro, then filter into sterile bottle through filter. Also Some people use regular faucet water and also have had no difficulties with this, but it work best if you take a look at plain tap water by reading the pdf your city/locale will created on water quality before determining how safe it is to work with. Make sure that you make sure you’re not injecting lead – if you’re moving into a structure that’s been around for some time, run the lake for two main minutes before collecting it. Even though you use a new building, the “lead free” pipes can still possess a tiny volume of lead in it ,so please run the faucet for some time nonetheless.
(The pin utilized for injecting in the sterile vial and relieving air pressure should live there together with the filter before process is completed. use the other pin to get water with.)
How to make Bacteriostatic Water
1.Use an alcohol swab to wipe off of the top of your benzyl alcohol vial.
2.Set up 0.1ml benzyl alcohol in a 10cc syringe
3.Write down 10ml sanitized water into 10cc syringe
4.Connect 0.22 pore filter to needle with BA and water
5.Push items in syringe into a 10cc sterile vile (remember to swab the top vial before step) and its particular Bac water!
When making bacteriostatic water, opt for the common 0.9% benzyl alcohol to 99.1% water ratio,don’t increase/decrease it without more capable.Make sure to add 1ml of sterile benzyl alcohol for every single 99ml water.